Configuration options for uIP
[The uIP TCP/IP stack]

uIP is configured using the per-project configuration file "uipopt.h". More...

Modules
	Static configuration options
	These configuration options can be used for setting the IP address settings statically, but only if UIP_FIXEDADDR is set to 1.
	IP configuration options
	IPv6 configuration options
	UDP configuration options
	TCP configuration options
	The name of the function that should be called when UDP datagrams arrive.
	ARP configuration options
	layer 2 options (for ipv6)
	6lowpan options (for ipv6)
	General configuration options
	CPU architecture configuration
	The CPU architecture configuration is where the endianess of the CPU on which uIP is to be run is specified.
	Application specific configurations
	An uIP application is implemented using a single application function that is called by uIP whenever a TCP/IP event occurs.
Files
file	uipopt.h
	Configuration options for uIP.

---

Detailed Description

uIP is configured using the per-project configuration file "uipopt.h".

This file contains all compile-time options for uIP and should be tweaked to match each specific project. The uIP distribution contains a documented example "uipopt.h" that can be copied and modified for each project.

Note:

Contiki does not use the uipopt.h file to configure uIP, but uses a per-port uip-conf.h file that should be edited instead.